Hi,
As discussed earlier, I was told that if I point a configuration to an AD group, as users are added to the group they will be added to the configuration.
I have to modify the configurations and hit deploy again in order for it to see the new users added to the AD group.
Am I missing a setting or does it have a set time that it checks for new AD group users and the modify deploy just forces the check?
Also, if I hit deploy it always says the switch is not defined for the software package.
The switch is there /VERYSILENT.
I have to click modify package and save. I do not change any details, but it works after I do this.
Thanks,
-Ben